This configuration information is intended for Blackboard* LMS Administrators.

(*Blackboard Ultra Instructions can be found at the bottom of the article!)

Please use the following configuration information to create the BryteWave LTI 1.3 Tool in your Blackboard environment.

1. Navigate to the System Admin area for your Blackboard environment, then select LTI Tool Providers.

2. Select Register LTI 1.3/Advantage Tool. 

3. Enter the following information, then select Submit. 

Client ID: bf0a576c-eb4d-4ab8-8b68-54fe33dbbbe5 

4. After the information for the LTI 1.3 Tool populates, copy the Deployment ID. You will provide the Deployment ID to RedShelf to complete enablement of your BryteWave LTI 1.3 Tool.

5. Scroll down and ensure the following items are enabled: 

• • Tool Status: Approved 
  • User Fields to Send:
    -Role in Course [check this box]
    -Name [check this box]
    -Email Address [check this box] 

• Allow grade service access: Yes
• Allow Membership Service Access: Yes 

6. Select Submit. A BryteWave LTI 1.3 Tool is now created in your Blackboard environment. 

7. In the TOOL/PROVIDER section, hover over the RedShelf tool and select the down carrot to the right of the name, followed by Manage Placements. 

 

8. Select Create Placement, then enter the following information and select Submit: 

• • Label: BryteWave Deep Link 
  • Handle: BryteWaveDL 
  • Availability: Yes 
  • Type: Deep Linking content tool 
  • Launch in New Window: [check this box] 
  • Target Link URI: https://redshelf.com/lti1p3/dl 

9. Select Create Placement, then enter the following information and select Submit: 

• • Label: BryteWave Course Materials 
  • Handle: BryteWaveCM 
  • Availability: Yes 
  • Type: Course content tool o Allows grading: [check this box] 
  • Launch in New Window: [check this box] 
  • Target Link URI: https://redshelf.com/lti1p3/section 

10. Navigate to a course and select Content on the left-hand navigation menu. 

11. Select Build Content on the top navigation bar, then select BryteWave Course Materials and enter the following information: 

• • Name: BryteWave Course Materials 
  • Enable Evaluation: No 
  • Permit Users to View this Content: Yes 

12. Select Submit. This places a link to BryteWave into your LMS course. 

13. Provide the Deployment ID to your RedShelf account representative. They will enable your BryteWave LTI 1.3 Tool link. 

Once LTI 1.3 is enabled by your RedShelf account representative… 

14. Click the BryteWave Course Materials link to ensure your LTI 1.3 Tool has been configured correctly. 

NOTE: Your screen may have the red message in the screenshot below. This is expected behavior, and does not mean your LTI Tool is misconfigured.

 FACULTY SETUP INSTRUCTIONS: